This is wrong!
On the forum I found these instructions:
I don't know yet what this means. I'll try and figure it out.
So. first I will print the neckplate.
Thursday, January 10, 2019
Assembling the Inmoov - Getting Started
I now have enough parts printed and my printer is cranking out new parts so that i thought I would start putting it together. I went to the website instructions and step 1 was right away a problem. Under neck and jay, I was told to: "Glue or screw “MainGear” to “NeckHinge” but I could not find any neckhinge anywhere in the STL files. What?? It turns out that it is the old instructions to the old files. I am not encouraged by this. This is a daunting project and already I have a doubt and uncertain about what I am supposed to do. That is why I am back here working on this blog!
Subscribe to:
Post Comments (Atom)
-
Following my first disaster of ripping a hole in the plate blanket in order to get my ear off, I put a new one on and had the same problem a...
-
I now have enough parts printed and my printer is cranking out new parts so that i thought I would start putting it together. I went to the ... -
By now I have printed all of the head and face parts except for the ears. I have the speakers so I am using the design for them. I printed t...
No comments:
Post a Comment